Hi-Port HP-25 PROFIBUS cable testers.
This small handheld device PROFIBUS cable tester checks for the most frequently found cable connection faults seen with PROFIBUS DP wiring between pairs of 9-pin D-sub PROFIBUS plugs and over daisy chained PROFIBUS cables. Ideal for network cable checks by unskilled wiremen.
The software checks for and reports open lines, short circuits between cores, shorts between screen and cores, and crossed connections, reporting any such failures on a red background, with sound signal and text details shown on the front panel colour display. Correct connection test results are reported on a green screen, with different sound signal and show the number of activated terminator switches detected on the tested cable. If 3 or more terminators are detected this is reported as a fault.
Fault details are emphasized by display of associated conductor colour information, showing green background for A line, red background for the B line and black for the cable screen/shield.
In addition to connection testing, the unit also allows test tone output onto the PROFIBUS A line, to enable clear separation of IN and OUT cables at a remote location before connection to plug or other unit. Correct orientation of cables within all PROFIBUS plugs and slaves is very important. A tone detector is included for identification of these signals : this unit, as shown in following photo, includes separate tone generation module for tracing LAN, telecom or other wires. Both modules are powered by button cells which are included.
The HP-25 PROFIBUS Cable Tester kit is supplied with silver end of cable test plug, two 9 volt PP3 batteries and tone detector, all in strong hard carry case.
Note: this tester is only suitable for use on totally unpowered cables.